Index: lvs/debian/config/etc/nagios/nrpe.cfg
===================================================================
--- lvs/debian/config/etc/nagios/nrpe.cfg	(revision 713)
+++ lvs/debian/config/etc/nagios/nrpe.cfg	(revision 1002)
@@ -3,5 +3,5 @@
 # Written by: Ethan Galstad (nagios@nagios.org)
 # 
-# Last Modified: 03-05-2003
+# Last Modified: 11-23-2007
 #
 # NOTES:
@@ -12,4 +12,19 @@
 
 
+# LOG FACILITY
+# The syslog facility that should be used for logging purposes.
+
+log_facility=daemon
+
+
+
+# PID FILE
+# The name of the file in which the NRPE daemon should write it's process ID
+# number.  The file is only written if the NRPE daemon is started by the root
+# user and is running in standalone mode.
+
+pid_file=/var/run/nrpe.pid
+
+
 
 # PORT NUMBER
@@ -96,4 +111,28 @@
 
 command_timeout=60
+
+
+
+# CONNECTION TIMEOUT
+# This specifies the maximum number of seconds that the NRPE daemon will
+# wait for a connection to be established before exiting. This is sometimes
+# seen where a network problem stops the SSL being established even though
+# all network sessions are connected. This causes the nrpe daemons to
+# accumulate, eating system resources. Do not set this too low.
+
+connection_timeout=300
+
+
+
+# WEEK RANDOM SEED OPTION
+# This directive allows you to use SSL even if your system does not have
+# a /dev/random or /dev/urandom (on purpose or because the necessary patches
+# were not applied). The random number generator will be seeded from a file
+# which is either a file pointed to by the environment valiable $RANDFILE
+# or $HOME/.rnd. If neither exists, the pseudo random number generator will
+# be initialized and a warning will be issued.
+# Values: 0=only seed from /dev/[u]random, 1=also seed from weak randomness
+
+#allow_weak_random_seed=1
 
 
@@ -160,4 +199,17 @@
 command[check_procs_z]=/usr/lib/nagios/plugins/check_procs -w $ARG1$ -c $ARG2$ -z $ARG3$
 
-
+#command[check_users]=/usr/lib/nagios/plugins/check_users -w $ARG1$ -c $ARG2$
+#command[check_load]=/usr/lib/nagios/plugins/check_load -w $ARG1$ -c $ARG2$
+#command[check_disk]=/usr/lib/nagios/plugins/check_disk -w $ARG1$ -c $ARG2$ -p $ARG3$
+#command[check_procs]=/usr/lib/nagios/plugins/check_procs -w $ARG1$ -c $ARG2$ -s $ARG3$
+
+#
+# local configuration:
+#	if you'd prefer, you can instead place directives here
 include=/etc/nagios/nrpe_local.cfg
+
+# 
+# you can place your config snipplets into nrpe.d/
+include_dir=/etc/nagios/nrpe.d/
+
+